Turbo 400 Pulling Truck

This 400 is specifically built for pulling trucks. The gear standard selection is the 2.48 ratio. Used is stock transfer case applications where only 1st gear is used. The transmission retains 1st-3rd and Reverse. 3rd and reverse are only to move the truck around the pit. We remove the 2nd gear so the internals will spin up fast. No sprag!!! This makes for a super strong assembly with 13lbs less rotating mass to spin up when you drop the hammer. There are several ratios available.  Std ratio is 2.48. Others are 2.75, 2.98. Many have been very successful with this combination. We are sure you will to.

• Manual Reverse Shift Pattern P-R-N-1-1-3
• Ultrabell Chevy/BOP pattern
  
• Media Blast Case Prep for Racing
• Hytuff Input Shaft
• CNC Forward Drum for Oversize splines
• Intermediate Snap Ring Case Support
• Clutch Hub Rollerised
• 2.48 Rollerised Gear Set
• Rear Case Torrington Thrust Bearing
• Heat Treated Main Shaft
• Harden Stator Support
• Tube Shaft Modification 
• Low Drag Option
• Tensioned Sealing Rings
• High Energy Expanded Capacity Clutch Packs
• Coated Fasteners
• Charge Pressure Modification  (saves engine thrust bearing)
• Deep Pan
• Hi Flow Filter Assembly
• 1 Year Warrant